BENDIX GEN 4 GEN 5 ABS Manual del operador Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Selecting a Protocol & Registering the ECU
NEXIQ Brake-Link™ Bendix
®
& Eaton
®
ABS Applications 21
Both
Bendix
®
and Eaton
®
ABS Applications require you to select a hardware/
communication protocol in order to establish a connection to the ECU. In other
words, you must tell Brake-Link which Data Bus to use for communications:
J1708/J1587 BUS
or
PLC/ENHANCED MODE
. Use the following table to help
you decide which protocol best suites your needs.
J1708/
J1587
Benefits:
provides ECU access via a standard Deutsch con-
nection
supported by all Bendix
®
brake ECUs
Considerations:
ECU access typically requires connecting to the
tractor and trailer separately
some
trailers
do not provide Deutsch connectors
if youre diagnosing a trailer that
isn’t
connected to a
tractor, an external power supply and adapter is re-
quired in
addition
to the Deutsch adapter
Use if:
the ECU youre testing doesnt support Enhanced
PLC Mode, i.e., Gen 4 or EC-17
the ECU youre testing supports, but is not config-
ured for, Enhanced PLC Mode; once you enable it,
you can use either protocol
PLC/
Enhanced
Mode
Benefits:
provides ECU access via a Deutsch
or
J560 Power
Line Connection
if the tractor is attached to the trailer, it provides ac-
cess to both ECUs via a single connection
provides access to the
trailer
ECU if there is no
Deutsch Connector available
Considerations:
the applicable ECU(s) must support Enhanced PLC
Mode (see pg. 30) to utilize this protocol
Use if:
the tractor is connected to the trailer and you need
to communicate with the trailer or both ECUs
there is no Deutsch Connector available on the trail-
er
youre testing a trailer that is not connected to a trac-
tor
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 111 112

Comentarios a estos manuales

Sin comentarios