BENDIX AD-2 AIR DRYER Manual de usuario

1FIGURE 1 - AD-IS® EVERFLOW™ ASSEMBLY, AD-IS® AIR DRYER, AND EVERFLOW™ ELECTRONIC MODULEBendix® AD-IS® EverFlow™ Assembly SD-08-2417GOVERNORAD-IS® AIR

10BW2077 © 2007 Bendix Commercial Vehicle Systems LLC All rights reserved. 10/2007 Printed in U.S.A.METALBLACK RUBBERFIGURE 7- IDENTIFICATION OF

2Additionally, the AD-IS® EverFlow™ assembly controls the compressor/dryer charge cycle. AD-IS® EVERFLOW™ AIR DRYER OPERATION: GENERALThe AD-IS® EverF

3FIGURE 2 - AD-IS® AIR DRYER SYSTEM SCHEMATICcharge cycle until the air brake system pressure builds to the governor cut-out setting of approximately

4the turbo cut-off valve to close off the supply of air from the compressor (this will be further discussed in the Turbo Cut-off Feature section). Wat

5WARNING!This air dryer is intended to remove moisture and other contaminants normally found in the air brake system. Do not inject alcohol, anti-free

6working in the engine compartment, the engine should be shut off and the ignition key should be removed. Where circumstances require that the engine

7TESTING THE AD-IS® EVERFLOW™ ASSEMBLYBefore placing the vehicle in service, perform the following tests.1. Close all reservoir drain valves.2. Buil

8CLEANING & INSPECTIONConsult the service data sheet for the dryer used in your AD-IS® EverFlow™ assembly. The service data sheet contains inform

9ASSEMBLY1. Lubricate the smaller o-ring and check valve body with barium or silicon grease.2. Install this o-ring on the check valve body by slidin