BENDIX MC-12 MODULATOR CONTROLLER ASSY Información técnica descargar pdf (Pagina 33)

Steering Angle Sensor Tests

1. Measure resistance between input voltage and ground

at the sensor wiring harness connector.

Test Measurement

Power and Ground Input 8 to 16 volts

2 = Power Input

1 = Ground Input

Troubleshooting Diagnostic Trouble Codes:

Steering Angle Sensor (SAS-60

™

sensor) (continued)

2. Verify wiring between the Steering Angle Sensor and

the ECU.

SAS Wire Harness ECU Wire Measurement

Terminal Harness Terminal

4 7 Verify Continuity

3 8 Verify Continuity

Looking into wire harness connector

3. Verify wiring between the Steering Angle Sensor and

power/ground.

SAS Wire Harness Terminal Measurement

4 to Voltage & Ground Verify open circuit (no continuity)

3 to Voltage & Ground Verify open circuit (no continuity)

4. To perform a calibration procedure of the Steering Angle

Sensor, ACom

™

Diagnostics V4.0 is required. Using

the program, select the “Conﬁguration” option, followed

by the “Calibrate” option. The following screen should

be displayed.

5. Follow the prompts to perform a calibration of the

Steering Angle Sensor.

6. To test the Steering Angle Sensor, ACom V4.0

is required. Using Bendix ACom V4.0, select the

“Component Test” option, followed by the “ESP Test”

option. The following screen should be displayed.

7. Follow the prompts to perform a test of the Steering

Angle Sensor.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Sin comentarios

BENDIX MC-12 MODULATOR CONTROLLER ASSY Información técnica Pagina 33