BENDIX BW2768 Manual de usuario descargar pdf (Pagina 20)

Troubleshooting

▲

WARNING

The vehicle’s ignition must be on and the transmission in reverse for the

Bendix

™

BackSpotter

system to power up. When testing and troubleshooting

the system, make sure (1) the ENGINE IS OFF, (2) the truck is in park on a level

surface, and (3) the parking brakes are properly set.

The Bendix

™

BackSpotter

system has built-in self test diagnostics and will warn the

driver if the system detects a failure within the radar sensor. In the event the system

self-test detects a failure, all ﬁ ve of the LEDs on the rear sensor display will ﬂ ash

along with a warning tone.

The following are typical symptoms and the possible causes:

All ﬁ ve LEDs on the rear sensor display unit are ﬂ ashing.

• The self-test has detected a failure within the radar sensor.

• Inspect the radar sensor for proper mounting, debris buildup, or

damage.

• Inspect the wiring harness for damage or corrosion.

The green power LED on the rear sensor display does not

illuminate when the vehicle is placed in reverse.

• The Bendix

™

BackSpotter

system is not powering up.

• Check for power to the reverse lamp circuit.

• Check the Bendix

™

BackSpotter

harness power connections,

inspect for damage or corrosion.

• Check for battery power at pin 1(+) and pin 2(-) at harness

connector J1 (sensor).

• Check for system power (+5VDC) at pin 1(+) and pin 2(-) at

harness connector J2 (rear sensor display).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Sin comentarios

BENDIX BW2768 Manual de usuario Pagina 20