BENDIX BW2771 Manual de usuario descargar pdf (Pagina 10)

Product Safety Information

Pretest Procedures

Electrical Pretest

Overview

This test will verify that all electrical connections to the VORAD

VS-400 Forward Looking Radar (FLR) and the Driver Interface Unit (DIU)

are correct for proper operation. This test should be performed before beginning any of the Diagnostic Trouble Code (DTC) isolation

procedures.

Note: Refer to the Side Object Detection section for information on testing the Side Object Detection electrical connections.

 • Neverinserttestleadprobes,nails,orpaperclipsintothevehicleharnessconnectorterminals,asthiscandistortordamagethe

wire terminals.

 • Neverpiercewireinsulationtotestcircuits,asthiscanresultindamagedwiresandwirecorrosion.

 • Whenmakingresistancechecksoncircuits,makesurethevehicleignitionisofftopreventdamagetotestequipmentandvehicle

components.

Required Tools

 1. DigitalVolt/OhmMeter

WARNING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Sin comentarios

BENDIX BW2771 Manual de usuario Pagina 10