BENDIX BW2212 Manual de usuario descargar pdf (Pagina 24)

TROUBLESHOOTING

Troubleshooting Your Bendix

XVision

Night Vision System

Situation Possible Solutions

No image on the display. Bendix logo does not

appear during power-up, combiner and fold

mirror are open.

Check that the combiner is open to an angle that allows you to

see the image.

Make sure the vehicle accessory power, headlights, and the

XVision system are all on.

Check that the display intensity is set at an appropriate level to

view the image.

Check that the 25-pin connector of the display harness is com-

pletely plugged into the display and fastened.

Check the 25-pin display harness connections, reference

XVision system schematic, gure 43 on page 23 @

25-pin Description Voltage

2 Vehicle Ground ground

11 Headlamp + 12 Volts

13 Ignition + 12 Volts

Incorrect voltage value, ignition, headlamp,

ground, at 25-pin connector.

Check that the 3 A slow open fuse connecting the red wire of

the vehicle harness to the 12V battery is intact. Check that

there is 12 Volts at this location, using a multimeter.

Check that the 1 A fast open fuse connecting the blue wire

of the vehicle harness to the head lamp circuit is intact. With

headlamps on, check that there is 12 Volts at this location, us-

ing a multimeter.

Check the ground connection of the vehicle harness.

Check the 3-pin vehicle harness connections, reference

XVision system schematic, gure 43, on page 23 @

3-Pin Description Voltage

A Ignition + 12 Volts

B Vehicle Ground ground

C Headlamp + 12 Volts

Bendix logo remains on the display after 2

minutes.

Check that the video in/out switch is set to “out.” Reference

gure 13 on page 7.

Check that the 6-pin camera harness connector is plugged

completely into the IR camera, reference gure 21 on page 10.

Check that the terminals are seated and the wiring secure.

Check the 6-pin IR camera harness connections (2 pins not

used), reference XVision system schematic, gure 43 on

page 23 @

(

6-Pin Description Voltage

A IR camera power + 12 Volts

B IR camera ground ground

Check to see if the IR camera harness 8-pin connector is

plugged into the display harness 8-pin connector. Reference

gures 8 & 9 on page 5.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios

BENDIX BW2212 Manual de usuario Pagina 24

Comentarios a estos manuales