Windsor-Severence Fire Protection District
Heavy Rescue
Production Specification
SVI #774 Page 68 of 126 April 19, 2010
REAR CAB AREA LAYOUT
REAR CAB DESK - STRAIGHT
The rear wall of the cab shall be provided with a desktop which shall be approximately 24" deep x 40" wide and located
approximately 36" from floor. The front edge of the desk top shall be reinforced with 2" x 2" tubing in order to support a
person sitting on the edge of the desk. The desk top surface shall be fabricated of 3/16" smooth finish aluminum. It shall
have a 2" vertical downward edge along front to cover the 2" x 2" reinforcement.
There shall be 2-1/2" diameter holes with plastic edge grommet provided at each rear corner for wiring of future
equipment located on the desk top. The desk top shall be painted dark gray with a hammer tone powder coat paint finish
for a hard and durable surface.
PULL-OUT DESK EXTENSION
The rear crew area desk shall include a pull-out desktop extension located directly below the standard desktop. The pull-
out desk portion shall be fabricated from 3/16" smooth finish aluminum painted with a dry-erase outer surface. The pull-
out section shall be reinforced as necessary in order to support a person sitting on the pull-out section.
CAB INTERIOR CABINET - OVERHEAD
There shall be one (1) overhead cabinet(s) provided on rear wall of cab. Cabinet(s) shall be constructed of 1/8" smooth
finish aluminum, and painted with a dark gray hammer tone powder coat paint finish for a hard durable surface. Each
cabinet shall be approximately 14" high x 14" deep x 34" wide.
The above cabinet(s) shall have sliding clear Lexan door(s).
OVERHEAD RADIO MOUNTING CONSOLE
There shall be one (1) overhead radio mounting console provided in the cab command interior. The radio cabinet shall
provide mounting area for the radios specified and shall be approximately 14" deep by 4" high. The surface shall be
painted dark gray with a hammer tone powder coat paint finish for a hard and durable surface.
The radio cabinet shall be constructed of 1/8" smooth finish aluminum and front of the cabinet shall have standard bolt-on
8-1/2" x 4" black radio trim mounting plates. A hinged 3/16" aluminum drop down access cover shall be provided on the
bottom to access equipment mounting and wiring with 1/4 turn knobs to secure cover closed. Ventilation louvers shall be
provided for proper ventilation of radio equipment.
There shall be one (1) radio(s) mounted in the front face of the component console
CAB COMMAND 120V INTERIOR LIGHT(S)
There shall be one (1) 120 volt, interior light fixture(s) installed above the desk/deck area under the overhead cabinet(s).
Fixture shall be provided with single bulb and switch on fixture.
MAGNETIC WHITEBOARD
There shall be one (1) magnetic whiteboard(s), approximately 36" wide x 20" tall located on rear wall of cab.
(112 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales