Windsor-Severence Fire Protection District
Heavy Rescue
Production Specification
SVI #774 Page 92 of 126 April 19, 2010
CURBSIDE COMPARTMENT - AHEAD OF REAR WHEEL (C2)
The interior useable compartment width shall be approximately 64.0" wide.
The compartment door opening shall be approximately 57.0" wide.
This compartment shall have a Robinson roll-up door.
The roll-up door shall have an un-painted satin aluminum finish on the door slats and the door trim components.
There shall be NO keyed lock on this roll-up compartment door.
One (1) nylon strap shall be provided to assist in closing the door. The strap shall be fastened to the left side of
the lower inside door sill. The strap shall extend from the left side of the lower inside door sill to a footman loop
attached to the center of the left side of the door frame.
One (1) aluminum drip pan/door finish guard shall be provided with the rollup door.
Compartment threshold protection plate shall be installed on the bottom edge of the compartment door opening. The
threshold protection shall be fabricated from an aluminum extrusion with an anodized exterior finish.
COMPARTMENT COMPONENTS
There shall be vertically mounted aluminum shelf trac for shelving installation.
There shall be one (1) 400 lbs. slide-out tray(s) approximately 24" deep and as wide as the compartment layout or
door opening permits.
- 3M™ Diamond Grade™ Conspicuity striping shall be provided on the front face of the tray. The striping shall
be 2" wide and red/white in color.
There shall be one (1) 1,000 lbs. slide-out tray(s) with a OnScene Solutions base approximately 44" deep and as
wide as the compartment layout or door opening permits located above the level of the chassis frame rails.
- 3M™ Diamond Grade™ Conspicuity striping shall be provided on the front and side faces of the tray. The
striping shall be 2" wide and red/white in color.
There shall be one (1) OnScene Solutions heavy duty, slide-out vertical tool board(s) approximately 70" deep and
shall be located above the level of the chassis frame rails.
- The vertical tool board material shall be 3/16" smooth aluminum sheet.
- The tool board(s) will be bolted to compartment floor.
- 3M™ Diamond Grade™ Conspicuity striping shall be provided on both sides of the toolboard. The striping
shall be 2" wide and red/white in color.
There shall be one (1) transverse module(s) which extends to the opposite side of the body. (Specified in opposite
side compartment.)
- There shall be two (2) OnScene Solutions cargo straps provided to secure the stored equipment.
(112 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales