Windsor-Severence Fire Protection District
Heavy Rescue
Production Specification
SVI #774 Page 69 of 126 April 19, 2010
REAR CAB AREA OUTLETS
There shall be one (1) 120 VAC, 20 amp duplex, straight-blade receptacle (NEMA 5-20R) located below the specified
desk.
There shall be one (1) 120 VAC outlet strip(s) approximately 2' long with straight blade household type outlets. The outlet
strip shall be located centered on the top rear portion of the rear desk.
CAB INTERIOR CABINET - CURBSIDE REAR WALL
There shall be one (1) full height cabinet located in rear cab area. The cabinet shall be fabricated from 1/8" smooth
aluminum, and shall have a ROM un-painted roll-up door. The cabinet shall be finished with a dark gray hammer tone
powder coat paint for a hard and durable finish. The cabinet shall be approximately 26" wide x cab interior height (less 3")
x 20" deep.
There shall be one (1) OnScene Solutions LED Nightstik(s) mounted vertically inside the cabinet. The LED
Nightstik(s) shall be a 54" section.
There shall be three (3) vertically adjustable shelf/shelves in each of the above cabinets. It shall have a 1.25" lip
to contain items while minimizing space used.
One (1) 12 volt terminal block(s) installed to provide 12 VDC power for equipment supplied by the Windsor-
Severance Fire Protection District. The fuse block shall be located on the upper back wall of the cabinet, justified
to the inside wall.
There shall be one (1) 120 volt outlet(s) located inside this cabinet against the back wall unless noted otherwise.
- The outlet receptacle shall be 15 amp, straight-blade (NEMA 5-15R).
There shall be one (1) 120 volt outlet strip(s) approximately 4' long with straight blade household type outlets
provided with this outlet. The outlet strip shall be located along the back wall of the cabinet, justified to the inside
wall.
- Outlet(s) shall be powered by both the on-board generator and shore power system through a relay system.
CAB INTERIOR CABINET - STREETSIDE REAR WALL
There shall be one (1) full height cabinet located in rear cab area. The cabinet shall be fabricated from 1/8" smooth
aluminum, and shall have a ROM un-painted roll-up door. The cabinet shall be finished with a dark gray hammer tone
powder coat paint for a hard and durable finish. The cabinet shall be approximately 26" wide x cab interior height (less 3")
x 20" deep.
There shall be one (1) vertically adjustable shelf/shelves in each of the above cabinets. It shall have a 1.25" lip to
contain items while minimizing space used.
(112 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales